Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄Summary► ◄Example►                         ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     This function provides font selection in text (alphanumeric)
     display modes. For font selection in graphics (all-points-
     addressable) modes, see Int 10h Function 11h Subfunctions 20h-24h.
 
     If AL = 10h, page 0 must be active. The points (bytes per
     character), rows, and length of the refresh buffer are
     recalculated. The controller is reprogrammed with the maximum
     scan line (points - 1), cursor start (points - 2), cursor end
     (points - 1), vertical display end ((rows * points) - 1), and
     underline location (points - 1, mode 7 only).
 
     If Subfunction 10h is called at any time other than immediately
     after a mode set, the results are unpredictable.
 
     On the MCGA, a Subfunction 00h call should be followed by a
     Subfunction 03h call so that the ROM BIOS will load the font into
     the character generator's internal font pages.
 
     Subfunction 10h is reserved on the MCGA. If it is called,
     Subfunction 00h is executed.
 
     Subfunction 10h acts like Subfunction 00h, but it also adjusts
     character height according to the height of characters being
     loaded.
                                    -♦-