◄Syntax►  ◄Details►  ◄Example►                 ◄Contents►  ◄Index►  ◄Back►
──────────────────────────────────────────────────────────────────────────────
The ON STRIG statement is an event-trapping statement that specifies a
routine to branch to when joystick trigger n% is pressed.
 
ON STRIG(n%) GOSUB {linenumber | linelabel}
    ■ linenumber or    A linenumber value of 0 disables event trapping and
      linelabel        does not specify line 0 as the start of the
                       routine.
 
Usage Notes
    ■ The ON STRIG statement specifies only the start of an event-trapping
      routine. The ◄STRIG Statements► determine whether the routine is
      called and how events are handled when trapping is off:
 
        STRIG ON      Enables event trapping. Event trapping occurs only
                      after a STRIG ON statement is executed.
        STRIG OFF     Disables event trapping. Even if an event takes
                      place, it is not remembered.
        STRIG STOP    Suspends event trapping. Any events that occur are
                      remembered and are trapped as soon as a STRIG ON
                      statement is executed.
 
    ■ If your program contains event-handling statements and you are
      compiling from the BC command line, use the BC /W or /V option.
      (The /W option checks for events at every label or line number; the
      /V option checks at every statement.) If you do not use these
      options and your program contains event traps, BASIC generates the
      error message, "ON event without /V or /W on command line."
    ■ The RETURN linenumber or RETURN linelabel forms of RETURN can be
      used to return to a specific line from the trapping routine. Use
      this type of return with care, however, because any other GOSUB,
      WHILE, or FOR statements active at the time of the trap remain
      active. BASIC may generate error messages such as "NEXT without
      FOR." In addition, if an event occurs in a procedure, a RETURN
      linenumber or RETURN linelabel statement cannot get back into the
      procedure because the line number or label must be in the
      module-level code.