Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

The cursor is not on a program line that contains a valid
expression. The Instant Watch command expects the
cursor to be on an expression whose value you want to see.
 
Choose <OK> on the error message dialog box and reposition
the cursor within the expression you want to watch.
 
Tip: In a complex expression, it may be hard to decide
     where to put the cursor. You can unambiguously
     indicate what the Instant Watch command should watch
     by highlighting it. Just place the cursor on the
     extreme left or right end of the expression and
     press SHIFT+RIGHT or SHIFT+LEFT until the expression
     is highlighted.