Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     You specified a non-integer value while the current radix is octal
     or hexadecimal. Floating-point values are allowed only when the
     radix is decimal. To change the current radix from the command
     window, use the N[radixnumber] command.
                                    -♦-