Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     Compiler error C2833
 
     'operator symbol' is not a recognized operator or type
 
     The operator command was not followed by either an operator
     (to override) or a type (to convert).
 
     Make sure that the operator command is followed by an operator
     or a type.
                                    -♦-