Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄At Location/Expression True► ◄Mouse►       ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
       1. Use the arrow keys to select Break at Location if Expression
          is True.
 
       2. Press TAB to move the cursor to the Location box. Type the
          the location at which you want to set the breakpoint.
          CodeView checks the expression only at the given location in
          the program.
 
       3. Press TAB to move the cursor to the Expression box. Type a
          relational expression. Execution will break if this
          expression is true at the location you entered in step 2.
 
       4. If you want CodeView to pass over the breakpoint a given
          number of times, press TAB to move the cursor to the Pass
          Count box. Type the number of times to pass over the
          breakpoint.
 
       5. If you want CodeView to execute commands after execution
          breaks, press TAB to move the cursor to the Commands box.
          Type the commands you want to execute.
 
       6. Press TAB to move the cursor to <OK>, and press ENTER.
 
     See: ◄Break Addresses►
          ◄Expressions in CodeView►
          ◄Break if Expression is True►
                                    -♦-