Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Syntax►
────────────────────────────────────────────────────────────────────────────
 
                        DRVSPACE /RATIO ── Examples
 
To change the estimated compression ratio of all your compressed drives to
match each drive's actual compression ratio, type the following command:
 
    drvspace /ratio /all
 
To change drive D's estimated compression ratio so that it is 3.2 to 1, you
would type the following:
 
    drvspace /ratio=3.2 d:
 
To change the estimated compression ratio of the current drive to 6 to 1,
you would type the following:
 
    drvspace /ratio=6
 
To have DriveSpace adjust the compression ratio for all your drives each
time your computer starts, add the following command to the end of your
AUTOEXEC.BAT file:
 
    drvspace /ratio /all
 
                                      ♦