Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Notes►  ◄Example►
────────────────────────────────────────────────────────────────────────────
 
                                 LASTDRIVE
 
Specifies the maximum number of drives you can access. You can use this
command only in your CONFIG.SYS file.
 
The value you specify represents the last valid drive MS-DOS is to
recognize.
 
Syntax
 
    LASTDRIVE=x
 
Parameter
 
x
    Specifies a drive letter in the range A through Z.
 
                                      ♦