Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Examples►  ◄Syntax►
────────────────────────────────────────────────────────────────────────────
 
                               NLSFUNC──Note
 
The default value for [drive:][path]filename is defined by the COUNTRY
command in your CONFIG.SYS file. If no COUNTRY command exists in CONFIG.SYS,
Nlsfunc looks for COUNTRY.SYS in the root directory of the startup drive.
Nlsfunc does not access the COUNTRY.SYS file until MS-DOS requests
information from it. If MS-DOS cannot find the COUNTRY.SYS file when you
install Nlsfunc, no error message is given. However, you will get an error
message if you subsequently run a CHCP command.
 
                                      ♦