Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Note►
────────────────────────────────────────────────────────────────────────────
 
                                 SETVER.EXE
 
Loads the MS-DOS version table into memory. This device driver must be
loaded by a <DEVICE> or <DEVICEHIGH> command in your CONFIG.SYS file.
 
SETVER.EXE loads into memory the MS-DOS version table, which lists names of
programs and the number of the MS-DOS version with which each program is
designed to run.
 
Syntax
 
    DEVICE=[drive:][path]SETVER.EXE
 
Parameters
 
[drive:][path]
    Specifies the location of the SETVER.EXE file.
 
                                      ♦