Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Notes►  ◄Examples►
────────────────────────────────────────────────────────────────────────────
 
                                    COPY
 
Copies one or more files to the location you specify.
 
This command can also be used to combine files. When more than one file is
copied, MS-DOS displays each filename as the file is copied.
 
Syntax
 
    COPY [/Y|/-Y] [/A|/B] source [/A|/B] [+ source [/A|/B] [+
    ...]][destination [/A|/B]] [/V]
 
Parameters
 
source
    Specifies the location and name of a file or set of files from which you
    want to copy. Source can consist of a drive letter and colon, a
    directory name, a filename, or a combination.
 
destination
    Specifies the location and name of a file or set of files to which you
    want to copy. Destination can consist of a drive letter and colon, a
    directory name, a filename, or a combination.
 
Switches
 
/Y
    Indicates that you want COPY to replace existing file(s) without
    prompting you for confirmation. By default, if you specify an existing
    file as the destination file, COPY will ask you if you want to overwrite
    the existing file. (Previous versions of MS-DOS would simply replace the
    existing file.) If the COPY command is part of a batch file, COPY will
    behave as in previous versions. Specifying this switch overrides all
    defaults and the current setting of the COPYCMD environment variable.
 
/-Y
    Indicates that you want COPY to prompt you for confirmation when
    replacing an existing file. Specifying this switch overrides all
    defaults and the current setting of the COPYCMD environment variable.
 
/A
    Indicates an ASCII text file. When the /A switch precedes the list of
    filenames on the command line, it applies to all files whose names
    follow the /A switch, until COPY encounters a /B switch, in which case
    the /B switch applies to the file whose name precedes the /B switch.
 
    When the /A switch follows a filename, it applies to the file whose name
    precedes the /A switch and to all files whose names follow the /A
    switch, until COPY encounters a /B switch, in which case the /B switch
    applies to the file whose name precedes the /B switch.
 
    An ASCII text file can use an end-of-file character (CTRL+Z) to indicate
    the end of the file. When combining files, COPY treats files as ASCII
    text files by default.
 
/B
    Indicates a binary file. When the /B switch precedes the list of
    filenames on the command line, it applies to all files whose names
    follow the /B switch, until COPY encounters an /A switch, in which case
    the /A switch applies to the file whose name precedes the /A switch.
 
    When the /B switch follows a filename, it applies to the file whose name
    precedes the /B switch and to all files whose names follow the /B
    switch, until COPY encounters an /A switch, in which case the /A switch
    applies to the file whose name precedes the /A switch.
 
    The /B switch specifies that the command interpreter is to read the
    number of bytes specified by the file size in the directory. The /B
    switch is the default value for COPY unless COPY is combining files.
 
/V
    Verifies that new files are written correctly.
 
Related Command
 
For information about copying directories and subdirectories, see the
<XCOPY> command.
 
                                      ♦