Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

◄Note►  ◄Example►
────────────────────────────────────────────────────────────────────────────
 
                                   FILES
 
Specifies the number of files that MS-DOS can access at one time. You can
use this command only in your CONFIG.SYS file.
 
Syntax
 
    FILES=x
 
Parameter
 
x
    Specifies the number of files that MS-DOS can access at one time. Valid
    values for x are in the range 8 through 255. The default value is 8.
 
                                      ♦