Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                              ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     MPC fatal error MP1001
 
     cannot open file : 'filename'
 
     The given file either did not exist, could not be opened, or was
     not found.
 
     One or more of the following can cause this error:
 
        ■ The file was read-only or was being used by another process.
 
        ■ An invalid filename or path was specified.
 
        ■ MPC ran out of file handles. To increase the number of
          available file handles, change the FILES setting in CONFIG.SYS.
          FILES=50 is the recommended setting.
 
        ■ The environment settings were invalid.
 
        ■ There was a disk media error or an open floppy disk drive
          door.