Programmer's WorkBench (pwb.hlp) (Table of Contents; Topic list)
Important Notice
The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.
Save Colors
                                             Up Contents Index Back
─────Programmer's WorkBench─────────────────────────────────────────────────
 
     Save Colors
 
     Choose Save Colors to save colors that you have changed in the
     Colors dialog box.
 
     The Modified Colors List box shows all the color settings that you
     changed in the Colors dialog box during the session.
     See: Color, Color Names Color Values
 
     To save all new settings:
 
       ■  Choose OK.
 
     To save only some of the new settings:
 
       1. Select the setting you do not want to save.
 
       2. Choose Delete.
 
          Repeat steps 1 and 2 above for each setting that you do not
          want to save.
 
       3. Choose OK.
 
     When you choose OK, PWB modifies the [PWB] section of your
     TOOLS.INI file for PWB colors and the [PWBHELP] section for
     PWBHELP colors to reflect the new switch settings. When you exit
     PWB, you are prompted to save TOOLS.INI. Your settings are not
     permanent until you actually save TOOLS.INI to disk.
 
     NOTE: If you started PWB with the /D or /DT (disable TOOLS.INI)
           command-line options, you cannot save new settings.
                                    -♦-