Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 
     factor: Format is '%f i' or '-f i'
 
     In incorrect format was specified in a Factor switch definition.
     The correct syntax is
 
     Factor:{%percent │ -constant} [count]
 
     <percent>    Percentage between 0 and 100 to reduce friction.
 
     <constant>   Constant value between 0 and 65,535 to reduce friction.
 
     <count>      Interval between reductions of friction.
 
     See: Factor
                                    -♦-