Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

   ◄Summary►  ◄Notes►  ◄Back►
──────────────────────────────────────────────────────────────────────────────
 
▀ When the Select Code Page subfunction is used, MS-DOS gets the new code
  page from the COUNTRY.SYS file. The device must be previously prepared
  for code page switching with the appropriate DEVICE= directive in the
  CONFIG.SYS file and NLSFUNC and MODE CP PREPARE commands (usually placed
  in the AUTOEXEC.BAT file).
                                    -♦-