Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

Use the Go To command to move the cursor to a specified
line number.
 
  1. Type the line number.
  2. Press ENTER or select <OK> to go to that line.
     Select <Cancel> to return to the QuickC editor.
 
┌────────────────────────────────┐
│Line:      [▒▒▒▒▒▒▒▒▒▒▒▒▒] ◄────│─ ■ Type line number
└────────────────────────────────┘    between 1 and 65535
 
TIPS: * To go to the end or beginning of the file use the
        CTRL+END or CTRL+HOME shortcut key.
      * The current line and column numbers are displayed
        in the lower right corner of the status bar.