Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

You executed part of your program during a debugging
session, then tried to turn debug history on.
 
Choose <OK> to stop program execution and turn debug
history on. QuickC automatically restarts the program
the next time you enter a Run (F5), Trace Into (F8), or
Step Over (F10) command.
 
Choose <Cancel> to continue executing the program and
leave debug history turned off.