Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 
  Use the Repeat Last Find command to repeat a search
  without retyping the previous search pattern.
 
  Repeat Last Find uses the same search string as the
  most recently executed Find or Change command.
 
  If no Find or Change command has been executed since
  you started QuickPascal, Repeat Last Find searches for
  the word at the cursor position. If the cursor is not
  on a word, the word to the left of the cursor becomes
  the target.