Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                                     ◄Up► ◄Next► ◄Previous►
────────────────────────────────────────────────────────────────────────────
 
include vmm.inc
 
mov     eax, Interrupt       ; interrupt number
mov     cx, Segment          ; segment selector for interrupt routine
mov     edx, Offset          ; offset to interrupt routine
VMMcall Set_PM_Int_Vector
 
The Set_PM_Int_Vector service sets the specified protected-mode interrupt
vector to the address of the given interrupt routine.
 
Parameter  Description
────────────────────────────────────────────────────────────────────────────
 
Interrupt  Specifies the number of the interrupt to set.
 
Segment    Specifies the selector of the code segment containing the
           interrupt routine.
 
Offset     Specifies the offset to the interrupt routine. If the code
           segment containing the routine is a 16-bit segment, the high word
           of this parameter must be zero.
 
Return Value
 
This service has no return value.
 
Comments
 
If the Set_PM_Int_Vector service is called before the Sys_VM_Init control
call, the installed interrupt routine becomes part of the default interrupt
vector table for every virtual machine. Otherwise, this service affects the
interrupt vector table for the current virtual machine only. By default,
each table entry points to a protected-mode breakpoint procedure that
reflects the interrupt to V86 mode.
 
Uses
 
Flags
 
See Also
 
Get_PM_Int_Vector, Set_PM_Int_Type, Set_V86_Int_Vector
 
 
                                      ♦