Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

 ◄Summary► ◄Description►                     ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     If you specify <breakaddress> as a line number, but the
     corresponding source line is a comment, declaration, or blank
     line, the following message appears:
 
          No code at this line number
 
     If an <offset> is given without a <segment>, the address in the
     CS register is used as the default segment.
 
     See: ◄Addresses►
          ◄Breakpoint and View Addresses►
                                    -♦-