Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     NMAKE Fatal Error U1060
 
     unable to close file : 'filename'
 
     NMAKE encountered an error while closing a file.
 
     One of the following may be a cause:
 
        ■ The file is a read-only file.
 
        ■ There is a locking or sharing violation.
 
        ■ The disk is full.
                                    -♦-