Important Notice

The pages on this site contain documentation for very old MS-DOS software, purely for historical purposes. If you're looking for up-to-date documentation, particularly for programming, you should not rely on the information found here, as it will be woefully out of date.

                                             ◄Up► ◄Contents► ◄Index► ◄Back►
────────────────────────────────────────────────────────────────────────────
 
     NMAKE Warning U4004
 
     too many rules for target 'targetname'
 
     More than one description block was specified for the given target
     using single colons (:) as separators. NMAKE executed the commands
     in the first description block and ignored later blocks.
 
     To specify the same target in multiple dependencies, use double
     colons (::) as the separator in each dependency line.
                                    -♦-